EVANS® DRUM HEADS EVANS Evans E-Ring Fusion 드럼 뮤트링 세트 10” 12" 14" 14" 뮤트링은 드럼을 뮤트하는 도구입니다. 예전엔 테이프나 휴지, 또는 파스를 이용해서 드럼을 뮤트하곤 했는데(?) 요즘엔 이 뮤트링이란 걸 많이 사용합니다. 만약에 여러분의 드럼이 튜닝을 했는데 울림이 너무 크거나 너무 텅텅거리고 소리가 마음에 안든다거나 드럼소리가 크다고 구박을 받는다면 이 뮤트링을 이용해보는 것도 괜찮은 방법입니다. 뮤트링을 드럼 위에 올려 놓아 보면 울림이 줄어들고 소리가 모아질 겁니다. 뮤트의 정도는 뮤트링을 적당한 크기로 잘라 사용하면 됩니다. drumheads E-RINGS ER-FUSION 14"x15" 1215 1017 DRUMKIT TUNING TIPS Below are general tuning tips that will lead you in the right direction to get the best sound and feel out of your drum kit Preparation Remove the drumhead. Use a dry, clean cloth to wipe off the hoop and bearing edge, removing any build-up that may have formed. Be sure to remove any debris that may have fallen into the drum. Tuning Sequence To seat the drumhead, use the tuning sequence that corresponds to the number of tension rods on your drum (pictured below). Technique Drum 8-Lug Drum 10-Lag Dram Step 1. Finger-tighten each tension rod until it touches the counter hoop. Step 2. Using your drum key, tension each rod by 1/4 turn increments until the head begins to resonate freely Continue tensioning the head by small increments until you reach a pitch SLIGHTLY higher than you desire. Excessive tensioning is not necessary and can often damage the head. Step 3. In 1/4 turn increments, de-tune the drum either using the tuning sequence or in clockwise movement until you reach the pitch you desire. Continue to "tweak" each keyrod by striking the head, then quickly turning the drum key counter-clockwise and then clockwise, up to pitch. Re-strike the head in the center and continue tweaking until you hear the clearest possible pitch. The ultimate goal is to make the head vibrate evenly. At this point, tune below, then upwards to the pitch you desire. Tuning relationship between the batter (top) head and resonant (bottom) head. TOMS Batter and resonant heads should be relatively close in pitch. and 5ths between the snare side and the batter head are good choices to Creating intervals of 3rd, 4ths SNARE Batter head equal or higher pitched than resonant (snare side) head. BASS DRUM Batter and resonant heads close to the same pitch. In most cases, this should be the lowest possible pitch just before the head begins to "wrinkle Slight ch ght changes in tension of the bass drum batter head will make big differences in the sound and feel of the bass drum pedal action OVERALL CONSIDERATIONS Find the right pitch for your drum and keep it there. Avoid tightening the drumhead every time you play. It is better to check the head daily and make small adjustments in tension rather than waiting and making large adjustments all at once. Even though new heads require a short break-in period, modern materials are extremely resilient and tend to hold pitch longer if they are always re-tuned to the original pitch at every session. Stay consistent and check the drum pitch before each rehearsal and performance, especially when the head is new. THE FIRST. THE FINEST. THE FUTURE.

상세 이미지의 글자를 옮긴 것입니다. 정확한 내용은 상세 이미지를 확인해 주세요.